Subject	If I'm reading that diagram correctly, it's for inputs, not>
Posted by	my91z on December 31, 2003 at 10:15 PM
	This message has been viewed 19 times.
In Reply To	Alpine doesn't recommend running that amp in 3 channels posted by NytWolf on December 31, 2003 at 09:56 PM
Message	outputs. When you "bridge" and amp, you usually do it by running the "+" from channel 1 and the "-" of channel 2 to the speaker(usually a sub, but not always). It's something you do physically with the wiring, not a switch you flip. Mike ------------------------------------------------------
Follow Ups	Amplifier advice needed. I don't know much about them >>>> - I am Z-ing Double 21:16:25 12/31/03 That amp is a 4-channel amp - NytWolf 21:20:42 12/31/03 Is it possible to run the front speakers with the amp, >> - I am Z-ing Double 21:30:04 12/31/03 Depends on the features of the cd player - BOOZTD 3 21:35:48 12/31/03 Yes > - my91z 21:36:48 12/31/03 Alpine doesn't recommend running that amp in 3 channels - NytWolf 21:56:54 12/31/03 If I'm reading that diagram correctly, it's for inputs, not> - my91z 22:15:02 12/31/03 You are right, but - NytWolf 22:19:43 12/31/03 Look at pages 16 and 18 >> - my91z 22:27:03 12/31/03 I understand, but page 16 is for the MRV-F450 and - NytWolf 22:31:28 12/31/03 What it doesn't show is a "mixed-mono" mode > - my91z 22:49:45 12/31/03 :) Yeah, I think you put it into better words than I could (n/m) - NytWolf 23:01:36 12/31/03 Actually, it does look like you do need to do something > - my91z 22:30:17 12/31/03 It WILL work, I'm not saying it won't, but I'm just - NytWolf 22:32:26 12/31/03 Just a note, i have an MRV-F302 for sale - BOOZTD 3 21:22:55 12/31/03 That amp has a really low RMS output. (n/m) - Slobo7x 01:42:30 01/01/04 Yeah, 35x4, but like I said, I don't need it to thump. >> - I am Z-ing Double 04:18:13 01/01/04 35W of "clean" power is plenty for 99% of people >> - my91z 10:38:52 01/01/04
Post a Followup	You cannot reply to this message because you are not logged in.