TwinTurbo.NET: Nissan 300ZX forum - Use 0.003" clearance. You dont need any more.
People Seeking Info
 
   


     
Subject Use 0.003" clearance. You dont need any more.
     
Posted by AshsZ(In Florida) on December 30, 2003 at 1:27 AM
  This message has been viewed 144 times.
     
In Reply To Ash, what about .0035? Are you runnin .003 in the posted by MikeH(Twin GT35BB Incon Z) on December 29, 2003 at 11:41 PM
     
Message The peacemaker is using the older cut pistons and 0.003" tolerance.. They make a little bit of noise, but after a 700HP+ pull they're actually rather quiet..



[ ashleypowers.com ]
[ agpowers@bellsouth.net ]

[ Zemulator Information Sheet ]

[ Z1 Motorsports Website ]

Enthusiasts soon understand each other. --W. Irving.
Are you an enthusiast?

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.