TwinTurbo.NET: Nissan 300ZX forum - .008" is the old cut. MAKE SURE your machinist goes ONLY
People Seeking Info
 
   


     
Subject .008" is the old cut. MAKE SURE your machinist goes ONLY
     
Posted by AshsZ(In Florida) on December 29, 2003 at 11:31 PM
  This message has been viewed 205 times.
     
In Reply To I had my machine shop check the taper last week, they posted by MikeH(Twin GT35BB Incon Z) on December 29, 2003 at 11:24 PM
     
Message to 0.003" piston-bore clearance. You got uncoated, right?



[ ashleypowers.com ]
[ agpowers@bellsouth.net ]

[ Zemulator Information Sheet ]

[ Z1 Motorsports Website ]

Enthusiasts soon understand each other. --W. Irving.
Are you an enthusiast?

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.