Subject	Going to dyno my car for the first time...any tips?
Posted by	jpark74 on December 29, 2003 at 5:23 PM
	This message has been viewed 61 times.
Message	I was searching the web for a place near me to get my alignment done since after getting eibach springs and the camber kit on, my z pulls hard to the left (maybe it was the pot holes in Ny.) I couldn't find any alignment shops that would take my Z but i did find a dyno shop less than a mile from i live. Don't know much about dynoing, but what the heck i'm thinking about getting it done anyways...all i know is that i should be in 4th gear...Any other helpful tips to get an accurate dyno? Here's their site...tell me if they seem ok...btw, if you know any good alignment places near Odenton, tell me. Also, the big question is, if my front aligment if a bit off, is it a really bad idea to dyno the car before i fix it? i figure it shouldn't really hurt anything... Their site
Follow Ups	Going to dyno my car for the first time...any tips? - jpark74 17:23:50 12/29/03 Tip of the day: remember to tie down the car :) (n/m) - Tissan 17:26:57 12/29/03 And don't hit the brakes on the dyno (n/m) - MikeH(Twin GT35BB Incon Z) 17:36:14 12/29/03 front wheels aren't on the rollers anyway - cant_z_me(retired) 17:27:32 12/29/03 make sure your car's maintenance is done... - japporeyser 17:29:42 12/29/03 Proper Preparation Prevents Piss Poor Performance. - AshsZ(In Florida) 19:07:39 12/29/03
Post a Followup	You cannot reply to this message because you are not logged in.