Subject	Hard to say without knowing the full extent of the damage.
Posted by	JRH(KY) on December 22, 2003 at 10:37 AM
	This message has been viewed 24 times.
In Reply To	Cost of replacing spun bearing on engine? posted by MasterChi on December 22, 2003 at 10:34 AM
Message	If there's no damage to the crank or rod the parts cost won't be too bad. The labor is what's going to get ya. _________________________________________________ "If you think someone else is going to solve your problem, then you have two problems." Jonathan Howlett AIM-JRHZ32 1993 Ultra Red Twin Turbo 1990 Pearl Yellow Twin Turbo(Deceased)
Follow Ups	Cost of replacing spun bearing on engine? - MasterChi 10:34:01 12/22/03 Hard to say without knowing the full extent of the damage. - JRH(KY) 10:37:06 12/22/03 cost in parts? maybe 20$ cost in labor? 1k-2500 depending - big gixx 10:37:14 12/22/03 Did the motor seize up? - Good2Zya 11:03:20 12/22/03 So it may be more advantageous to just replace.. - veritech137 11:54:48 12/22/03 Your piston might have hit the heads/valves because of the - MikeH(Twin GT35BB Incon Z) 12:40:57 12/22/03 been there, done that, 23 and change. (n/m) - chivas 15:03:07 12/22/03
Post a Followup	You cannot reply to this message because you are not logged in.