Subject	Only way to know for sure about the cams would be to measure
Posted by	speedr300z (ATL) on December 21, 2003 at 8:41 PM
	This message has been viewed 38 times.
In Reply To	JDM Engine Questions for my engine swap. posted by la300zxtt on December 21, 2003 at 05:03 PM
Message	them the intake cams... But more than likely they are the smaller "auto" cams.. And like HaloZ stated, the back of the crank will not have the usual pilot bushing, it will be a larger "spacer", which if you are installing a 5 speed, you will have to remove and install a Pilot bushing.. My New Project...
Follow Ups	JDM Engine Questions for my engine swap. - la300zxtt 17:03:26 12/21/03 the auto motors will not have a though out bearing. - Halo Z 17:19:03 12/21/03 i mean ***Pilot Bushing***not TO bearing. (n/m) - Halo Z 17:21:15 12/21/03 Thanks. (n/m) - la300zxtt 17:48:00 12/21/03 and throw not though (n/m) - robo (sebring1970) 18:28:29 12/21/03 Did not all J-Specs have the "Auto" turbos/cams? (n/m) - Snoguitar 17:48:50 12/21/03 Thats what I'm trying to figure out. - la300zxtt 18:00:35 12/21/03 What A/R does it say on the turbine housing? (n/m) - Snoguitar 18:09:08 12/21/03 n00b - Guapo 18:03:20 12/21/03 Just read it, doh! ;P (n/m) - Snoguitar 18:09:27 12/21/03 Read that also. - la300zxtt 18:11:55 12/21/03 Umm... are you sure you read that post? (n/m) - Snoguitar 18:15:00 12/21/03 Yes, and I saw the statement that Guapo made. - la300zxtt 03:03:58 12/22/03 *sigh* (n/m) - Spee 18:16:25 12/21/03 2nd (n/m) - Snoguitar 18:22:27 12/21/03 I just Dyno'ed my car with a automatic JDM Motor....> - Nostype2@aol.com 20:07:29 12/21/03 Weird, my JDM put down... - KaZ (VaBch) 09:17:04 12/22/03 Are either of you using auto/JDM turbos? - Chip(GMS Racing) 11:28:52 12/22/03 Only way to know for sure about the cams would be to measure - speedr300z (ATL) 20:41:38 12/21/03
Post a Followup	You cannot reply to this message because you are not logged in.