TwinTurbo.NET: Nissan 300ZX forum - yup.
People Seeking Info
 
   


     
Subject yup.
     
Posted by ni[X]it on December 17, 2003 at 10:12 PM
  This message has been viewed 100 times.
     
In Reply To Is it possible to "cap off" the rear brakes? posted by DJPurpose(Sacto,CA) on December 17, 2003 at 09:57 PM
     
Message You'll need to source the right parts, but basically you install a needle valve inline before the rear calipers.

you'll need to source two fittings, one needle valve, and an additional short length of pre-terminated brake line for each caliper.

Rough parts estimate is $30.oo a caliper.
Reassemble with teflon tape.

Don't forget to bleed the system properly before and after it's use.



"As the Z32 gets older and decreases in value it becomes affordable by lower income and often less desirable people whose tastes reflect their personality and social standing.- Marshall 17:37:05 10/10/03

Petz #3

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.