Subject	We have lots of good used ones
Posted by	Russell@Z1 on December 10, 2003 at 7:53 PM
	This message has been viewed 21 times.
In Reply To	Guys...How much For a Camshaft Angle Sensor circuit (CAS posted by E-ZTT on December 10, 2003 at 09:37 AM
Message	We would charge about $25 labor to install and set a CAS. [ www.300zx.com ] Russell Floyd Z1 Motorsports www.z1motorsports.com 1990+ Nissan Z specialists Used Parts, New parts, Service/Repair and Performance 1200 Carrollton Hwy Temple, Ga 30179 770-562-8668 770-562-8664 (fax)
Follow Ups	Guys...How much For a Camshaft Angle Sensor circuit (CAS - E-ZTT 09:37:27 12/10/03 call site sponsors. free labor. DIY. - nixit 09:44:10 12/10/03 did already...no prices just info..but thx (n/m) - E-ZTT 10:06:04 12/10/03 you called and they wouldnt give prices? thats weird. (n/m) - nixit 10:07:26 12/10/03 Re: No No...haven't done that yet (n/m) - E-ZTT 10:17:25 12/10/03 Easy DIY job. Might just be dirty. Have you cleaned it? (n/m) - longhornz32(Dallas) 09:55:08 12/10/03 Do some searching here 1st>> - Scott (NC) 10:23:52 12/10/03 and if it is bad, it's $290 for a new CAS from COZ (n/m) - ZBlacktt 10:40:32 12/10/03 Emailed your friend. No response. He still at that email - Milo (Sport Z Magazine) 11:44:16 12/10/03 I have an extra CAS.... - down5hift 10:45:08 12/10/03 We have lots of good used ones - Russell@Z1 19:53:57 12/10/03
Post a Followup	You cannot reply to this message because you are not logged in.