Subject	oh i think chameleon is a cool paint job, but not for a Z (n/m)
Posted by	JunomeanGF on December 04, 2003 at 11:57 PM
	This message has been viewed 21 times.
In Reply To	The paint job doesn't look bad in person posted by Evan(CA) on December 04, 2003 at 11:52 PM
Message
Follow Ups	FREE $500 in Nissan's parts dept. What would you buy? - ProfeZZor X 23:42:15 12/04/03 ouch! i was going to say something serious until i scrolled - JunomeanGF 23:45:37 12/04/03 The paint job doesn't look bad in person - Evan(CA) 23:52:44 12/04/03 oh i think chameleon is a cool paint job, but not for a Z (n/m) - JunomeanGF 23:57:51 12/04/03 big 2nd, saw it on a frod, looked ok, on Z = nasty (n/m) - Chickan_Z (OH) 01:03:06 12/05/03 Ouch,,lol When that paint cost more than your car,,lol. (n/m) - ZBlacktt 00:00:22 12/05/03 engine wiring harness (n/m) - TARGETZ 23:46:12 12/04/03 2nd (n/m) - JC (Vegas) 00:02:58 12/05/03 I think you should give it to me... I have lots of things - Jodecy 23:46:20 12/04/03 Engine Wiring Harness. (n/m) - Z Wang(Austin) 23:49:45 12/04/03 Sell it - Evan(CA) 23:50:40 12/04/03 Moulding on the Z is okay, but Peanut Oil works wonders too. (n/m) - ProfeZZor X 23:55:21 12/04/03 yes, I'll buy it for $100.01 Thanks ;) (n/m) - racespecifications 02:07:21 12/05/03 $500 off some 99 headlights :) (n/m) - ZBlacktt 00:17:24 12/05/03 Good thinking, I second that motion. (n/m) - Z PYRATE 00:49:03 12/05/03 get a spare spoiler... - MaxBoostTT 00:54:40 12/05/03 No longer made by Nissan. (n/m) - YugoBernie (NoVA) 01:22:40 12/05/03 both? (n/m) - Initial Z 02:42:53 12/05/03 No just the early one that is known for rotting. (n/m) - YugoBernie (NoVA) 09:18:42 12/05/03 engine harness. - 3 double-0 ZX(Va Bch) 01:33:30 12/05/03 Timing belt kit (n/m) - 400zx 02:08:48 12/05/03 2nd. If you plan to keep your Z a long time. Just pd 350 - twinhairdryers 02:12:55 12/05/03 complete body molding kit, use the rest for pre-paid - robo (sebring1970) 03:15:05 12/05/03 All the 60k service parts... - SooperZ95 08:33:14 12/05/03 You should get complete molding (n/m) - nismo805 10:24:41 12/05/03
Post a Followup	You cannot reply to this message because you are not logged in.