Subject	I was kind of wondering why this was an issue as well
Posted by	Carlos Ramirez on November 28, 2003 at 1:02 PM
	This message has been viewed 28 times.
In Reply To	12 inchs in a one ft. lb. (n/m) posted by MikeH(Twin GT35BB Incon Z) on November 28, 2003 at 11:57 AM
Message	Basically put the wrench at 240 in lbs. I think 100lbs is a bit high I normally do 80ft/lbs
Follow Ups	did I get the wrong torque wrench? - zboost 10:05:25 11/28/03 yep .. wrong one. But that one comes in handy for other stuf (n/m) - Guapo 10:16:41 11/28/03 Why is it the wrong one? What would be the right one? (n/m) - unluky 10:21:15 11/28/03 Not enough torque capacity. - Guapo 10:29:29 11/28/03 Aaaaa - I got ya. Missed the inch/foot part. Thanks (n/m) - unluky 10:35:28 11/28/03 As Guapo said, divide 250 in. lbs. by 12 and that - whitepearlz 10:30:56 11/28/03 thanks guys, just went and got the one guapo recomended (n/m) - zboost 11:53:12 11/28/03 12 inchs in a one ft. lb. (n/m) - MikeH(Twin GT35BB Incon Z) 11:57:08 11/28/03 I was kind of wondering why this was an issue as well - Carlos Ramirez 13:02:36 11/28/03 ehhh .... 240 in-lbs gets you 20 ft-lbs (n/m) - Guapo 13:04:36 11/28/03
Post a Followup	You cannot reply to this message because you are not logged in.