Subject	Good to hear
Posted by	FlawleZ on November 09, 2003 at 8:55 PM
	This message has been viewed 22 times.
In Reply To	FINALLY! something goes right for a change! posted by joel(PA) on November 09, 2003 at 08:37 PM
Message	I can't wait to see your dyno results.
Follow Ups	FINALLY! something goes right for a change! - joel(PA) 20:37:55 11/09/03 a few questions - Janders 20:49:04 11/09/03 stock bolts, 90lbs, smallest tomei gasket they make (n/m) - joel(PA) 21:30:29 11/09/03 Did you use the angular-torque method? (n/m) - ni[X]it 21:39:44 11/09/03 Good to hear - FlawleZ 20:55:47 11/09/03 Congrats! (n/m) - ni[X]it 21:39:21 11/09/03 Glad to hear the car is doing better.Now go dyno that thing! (n/m) - sleek 22:24:57 11/09/03 Isn't stock torque 90lbs? Where did you get 115lbs from? (n/m) - MikeH(Twin GT35BB Incon Z) 23:51:40 11/09/03 leaking @ 90lbs. was hoping for a better seal. dint work (n/m) - joel(PA) 22:05:54 11/10/03 Nice! (n/m) - chivas 07:33:22 11/10/03
Post a Followup	You cannot reply to this message because you are not logged in.