Subject	Re: Nice. Yeah, I didn't have any fitment problems when I
Posted by	kuah@splparts.com on November 08, 2003 at 11:22 AM
	This message has been viewed 106 times.
In Reply To	Nice. Yeah, I didn't have any fitment problems when I posted by Milo (Sport Z Magazine) on November 08, 2003 at 10:55 AM
Message	I measured them as well as a set of Greg Dupree downpipes... the difference was 1/8". If I remember right, the RVM downpipe is approx 2 1/4" ID 2 3/8" OD and the Greg Dupree downpipe is approx 2 3/8" ID 2 1/2" OD. The Greg Dupree pipes are smoother on the inside, but they are also $$$...
Follow Ups	RVM dp pix installed. - Zmas 00:56:57 11/08/03 Re: RVM dp pix installed. - ghoztt 01:12:27 11/08/03 your up past your bedtime no? - Zmas 01:24:06 11/08/03 Re: your up past your bedtime no? - ghoztt 02:41:48 11/08/03 no need - Spee 11:05:44 11/08/03 *saved* (n/m) - genic 01:36:51 11/08/03 Check your email addy in your profile. Didn't work last week - BCs300z 01:24:40 11/08/03 Corrected it. Thanks for the heads up! (n/m) - Zmas 01:27:30 11/08/03 It looks real nice....but I hate to say this, I did my - Zenn 01:28:12 11/08/03 I hear you but I have a few things missing that keep me - Zmas 01:33:44 11/08/03 I know what you mean... - Zenn 01:39:42 11/08/03 how much did the rvm dp cost? (n/m) - Solo Z32 01:46:43 11/08/03 I'll bet cheaper than the GD's (n/m) - FlawleZ 01:51:31 11/08/03 they're also 2.25" instead of 2.5" FYI (n/m) - fourZero 11:41:22 11/08/03 Hmmm...that's not what their website says >> - hoss 11:48:16 11/08/03 I believe they are measuring the OD not ID (n/m) - Zmas 12:22:27 11/08/03 Thats the beautiful part about all this. I believe about - Zmas 01:57:59 11/08/03 did your Z specialist have to R&R the tranny to install... - ForceFedTT 10:42:05 11/08/03 you don't have to... - Spee 11:06:42 11/08/03 Yah they dropped the tranny. (n/m) - Zmas 12:23:00 11/08/03 Nice. Yeah, I didn't have any fitment problems when I - Milo (Sport Z Magazine) 10:55:44 11/08/03 Re: Nice. Yeah, I didn't have any fitment problems when I - kuah@splparts.com 11:22:32 11/08/03
Post a Followup	You cannot reply to this message because you are not logged in.