Subject	Re: Somebody was posting about the Jun stroker kit earlier
Posted by	(SHOWTIME!) on November 07, 2003 at 1:43 PM
	This message has been viewed 75 times.
In Reply To	Somebody was posting about the Jun stroker kit earlier posted by FantasyZ on November 07, 2003 at 01:20 PM
Message	Stroker motors tend to have a better rod ratio. the longer rod causes less side loading on the cylinder wall from the piston. The downside is piston speed. I`ve built a few small block ford strokers in the past and they are an awesome way to wring more power out of a motor. Just make sure that the stroker it is complete and pay extreme attention to the block machine work, otherwise you`ll have (or could have, anyway)deck clearance issues. Hope that sheds some light for you!
Follow Ups	Somebody was posting about the Jun stroker kit earlier - FantasyZ 13:20:41 11/07/03 Re: Somebody was posting about the Jun stroker kit earlier - (SHOWTIME!) 13:43:47 11/07/03 I heard longer rods are better because of the piston - MikeH(Twin GT35BB Incon Z) 13:57:28 11/07/03 But the JUN kit does not use a longer rod. (n/m) - Chip(GMS Racing) 14:06:12 11/07/03 It can't, It would have to be shorter. Longer stroke - MikeH(Twin GT35BB Incon Z) 14:08:07 11/07/03
Post a Followup	You cannot reply to this message because you are not logged in.