TwinTurbo.NET: Nissan 300ZX forum - you're looking at the wrong bits.
Subject
you're looking at the wrong bits.
Posted by
Marshall
on November 07, 2003 at 12:36 PM
This message has been viewed
15
times.
In Reply To
I tried that, and it took a very long time...
posted by AztecTT
on November 07, 2003 at 12:08 PM
Message
The link you posted is a bit for a router.
Follow Ups
I went to Sears last night to get a carbide bit to file my
-
PLEAZURE in CA (SD)
11:41:14 11/07/03
Anything alum-oxide should be cool. (n/m)
-
Milo (Sport Z Magazine)
11:43:01 11/07/03
why carbide?
-
Marshall
12:03:33 11/07/03
I tried that, and it took a very long time...
-
AztecTT
12:08:03 11/07/03
you're looking at the wrong bits. -
Marshall
12:36:02 11/07/03
Well that was what I used, and it worked
-
AztecTT
12:42:49 11/07/03
whoops!
-
Marshall
12:50:20 11/07/03
I used something like this...
-
AztecTT
12:06:20 11/07/03
Re: I used something like this...
-
Marshall
12:39:28 11/07/03
2nd
-
slickboy
12:57:31 11/07/03
FYI I was able to change my #1 injector without the dremel
-
Japocalipse
12:09:44 11/07/03
You don't need to file/grind at all for #1 injector
-
SilverTwin(OH)
12:11:00 11/07/03
2nd. (n/m)
-
MaTT (90TT)
13:22:51 11/07/03
Are we talking about the same #1 is front driver side
-
PLEAZURE in CA (SD)
12:22:00 11/07/03
#1 is the front passenger side (n/m)
-
SWL
12:44:43 11/07/03
You're looking at the wrong bits.
-
Marshall
12:51:15 11/07/03
Thanks for the replies, I'll have to get a demel to change#2
-
PLEAZURE in CA (SD)
15:49:41 11/07/03
Quick hints from my experience
-
slickboy
21:02:10 11/07/03
Post a
Followup
You cannot reply to this message because you are not
logged in
.