TwinTurbo.NET: Nissan 300ZX forum - has anyone had any success using one manual boost controler¿
People Seeking Info
 
   


     
Subject has anyone had any success using one manual boost controler¿
     
Posted by DJPurpose(Sacto,CA) on November 04, 2003 at 12:38 AM
  This message has been viewed 76 times.
     
     
Message Would it be possible to take the two tubes that a boost jet would go into, combine them into one tube, connect a bleeder valve to adjust boost, then split the lines again so they can connect to their respective wastegates?

If I use two bleed valves there would be a good chance of one turbo boosting more than the other. This would eliminate this by equaling it out and making it easy to adjust.

Thanks


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.