Subject	big bore VG's?
Posted by	OCD-Z on October 25, 2003 at 5:50 PM
	This message has been viewed 164 times.
Message	i've heard of people boring there Z-based VG's over to as much as 90mm. any bigger might be approaching the VG Block's limits. but, however, from what i understand, the Cima-based VG's sidewalls are thicker, so: it's probable to bore a Cima-based VG over more than a Z-based VG, isn't it? so, if its possible to bore a Z's motor to ~3.2 liters, is it possible to bore a Cima's to ~3.3 liters? anyone: any thoughts?/ comments?/ experience?/ anything?
Follow Ups	big bore VG's? - OCD-Z 17:50:46 10/25/03 What are your goals w. your car? (n/m) - YugoBernie (NoVA) 17:52:26 10/25/03 i was actually just curious, but - OCD-Z 19:26:29 10/25/03 Then really all of this is way too much to spend on a NA. (n/m) - YugoBernie (NoVA) 21:30:34 10/25/03 this is true. just something to talk about. (n/m) - OCD-Z 11:25:39 10/26/03 There is a stroker kit that brings up displacement to 3.46L - Carlos Ramirez 17:56:05 10/25/03 and its cheap too =/ (n/m) - joel(PA) 18:06:15 10/25/03 yeah, whats it cost nowadays? $10,000 (n/m) - JMT-Z(St. Louis) 18:30:39 10/25/03 Jun kit (3.2L) = $11059 =) (n/m) - ZLover4Life 19:59:42 10/25/03 whats cheap to you? (n/m) - OCD-Z 19:27:11 10/25/03 Whatever it costs to make a convertible Z - ZLover4Life 21:41:19 10/25/03 i was being sarcastic. hence the =/ (n/m) - joel(PA) 21:55:57 10/25/03 where is the Sarcasm Police when you need them? (n/m) - Spee 22:31:36 10/25/03 Fresh batch was ready. - YugoBernie (NoVA) 01:12:28 10/26/03 resleeving? - Marshall 18:15:35 10/25/03 You sleeve the block.. The factory block is not sleeved (n/m) - Carlos Ramirez 22:41:34 10/25/03 Sounds like a lot of work. - Marshall 11:30:36 10/26/03 Its actually cheap to do it :-) - Carlos Ramirez 12:09:47 10/26/03 add material to the factory crank???????? - TagZ 09:20:27 10/27/03 yeap that correct :-) - Carlos Ramirez 21:57:18 10/27/03
Post a Followup	You cannot reply to this message because you are not logged in.