Subject	No clatter on mine... I had them make my set using .004" of
Posted by	AshsZ on October 21, 2003 at 3:35 PM
	This message has been viewed 66 times.
In Reply To	wiseco pistons posted by mrbc80 on October 21, 2003 at 02:54 PM
Message	taper rather than the .008" they are using. I did this because several cars I heard with them were making some clatter even when fully warmed up. It allows the piston to rock around too much and cause noise as they dont expand anywhere near .005" from cold to warm... Its more like only .001"-.002". Once my engine is fully warmed up, there is no noise from them at any time. This has been from my R&D on the piston design and they are currrently only available to other people as a 'custom' piston but Wiseco has been talking about making it a production run change and they will be made per my spec for everyone. We offer these pistons with this cut AND WITH polydyne coatings for $540. We feel that the price and perfomance of these pistons are unbeatable... and they wont make any noise.... [ ashleypowers.com ] [ agpowers@bellsouth.net ] [ Zemulator Information Sheet ] [ Z1 Motorsports Website ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast?
Follow Ups	wiseco pistons - mrbc80 14:54:18 10/21/03 I have Wiseco pistons, 87.5mm - therinL 15:16:35 10/21/03 Re: I have Wiseco pistons, 87.5mm - mrbc80 15:26:59 10/21/03 High boost on pump gas = ~15-16psi (n/m) - therinL 15:39:38 10/21/03 No clatter on mine... I had them make my set using .004" of - AshsZ 15:35:49 10/21/03
Post a Followup	You cannot reply to this message because you are not logged in.