Subject	I had Swain Tech coating done a while back. I haven't
Posted by	Milo (Sport Z Magazine) on October 20, 2003 at 11:02 AM
	This message has been viewed 85 times.
In Reply To	Swain coating posted by mrbc80 on October 20, 2003 at 10:44 AM
Message	completed my engine completely but I am hoping that it will eliminate a lot of the hot points on the pistons and heads. I could only afford to do the heads and pistons. One word of advise is to do them as close to the end of the completion as possible. The gold coating they use is excellent but it has to be installed in an engine in a certain times table or it begins to go bad. This is no BS, a friend did it on his pistons for his Honda and let the pistons sit for about 3 months and the coating went bad. I thought he was pulling my leg, but he was right... it did go bad. Don't know the details on it, I just rushed to install mine. That's about all I can say at this point on the issue. I'll post engine temps once the engine is up and running.
Follow Ups	Swain coating - mrbc80 10:44:08 10/20/03 This topic has been covered a couple times. - Kenny 14 psi 10:47:09 10/20/03 I believe Wagz had his pistons swain coated... - therinL 10:47:15 10/20/03 I had Swain Tech coating done a while back. I haven't - Milo (Sport Z Magazine) 11:02:14 10/20/03 I swain Coated the Piston in my 2-stroke 4-wheeler - Yuengling 11:04:42 10/20/03 yuengling = good stuff. (n/m) - Z U N L 21:36:22 10/20/03
Post a Followup	You cannot reply to this message because you are not logged in.