| Message |
When was the last time they came on this site and defended their product? It's almost like they're "too good" to entertain our comments and questions. You can count that no one representing Jim Wolf Technology will show up, which is really a shame because (while I think Boost Solutions and Ash will give the best representation possible, all they're really doing for a perfect comparison is swapping out ECU's and making sure the temp is the same for all the runs - BASICALLY) he should be there to stand up for his product. And when he see's that both of these ECU's are outperforming his (and they did according to the last post about these ECU's and will again) maybe he should get back to the drawing board. Someone should take a dyno chart of this over to his ass to show him that he's being outperformed by (no offense to ANYONE) rookies (compared to him) in the tuning game
 "all street races have three sides to the story... the one owners side, the other onwers side, and the truth" - Posted by gtclk on August 22, 2003 at 4:44 PM in response to cttt300zx's post on shaping carbon fiber: "you can try emailing me, but most likely, you wont like my reply. (nixit@juno.com)" - Posted by nixit on October 06, 2003 at 2:00 PM |
 |