Subject	OK, I checked the math on the circuit below:
Posted by	therinL on September 26, 2003 at 3:13 PM
	This message has been viewed 41 times.
In Reply To	A properly biased BJT or 2 would probably do the trick or: posted by therinL on September 26, 2003 at 02:26 PM
Message	[ http://www.twinturbo.net/net/viewmsg.aspx?forum=general&msg_id=1008892 ] Mathematically, it is all correct. This is about the simplest way you could get it to work. The value of the resistors doesnt weigh into the way the circuit works AS LONG AS they are all the same value. SO you could build that circuit with say 1k ohm resistors and it shodul work fine. Ill look at the prospect of a different method of doing the circuit some time this afternoon and post back tonight or tomorrow.
Follow Ups	Electronic's engineer. How do you make a a voltage - MikeH(Twin GT35BB Incon Z) 14:02:00 09/26/03 Huh? A feature of the Zem is already that it eliminates ... - spicyZ 14:13:59 09/26/03 I am going to run dual mafs. (n/m) - MikeH(Twin GT35BB Incon Z) 14:15:05 09/26/03 I'm a little slow today. (n/m) - spicyZ 14:30:39 09/26/03 should be pretty easy - aliaZ (IC Nazi) 14:24:30 09/26/03 That circuit will work but you DO need those resistors (n/m) - therinL 14:30:08 09/26/03 why do you say that? explain please (n/m) - aliaZ (IC Nazi) 14:32:53 09/26/03 Well... - therinL 14:42:00 09/26/03 im with you man. radio shack has some nice - Carlo$-91NA-2+2-5$p. 15:19:04 09/26/03 A properly biased BJT or 2 would probably do the trick or: - therinL 14:26:32 09/26/03 Sure, I would like that. (n/m) - MikeH(Twin GT35BB Incon Z) 14:29:05 09/26/03 me too please (n/m) - aliaZ (IC Nazi) 14:33:36 09/26/03 Me three please. - Woody75 (Denver) 15:06:27 09/26/03 OK, I checked the math on the circuit below: - therinL 15:13:28 09/26/03 Voila!! - BigTDogg (ZCON Whore) 14:42:29 09/26/03 Not ideal > - kuah@splparts.com 15:35:01 09/26/03 Yes, it is not linear. :( (n/m) - Funky (NWZ) 18:07:47 09/26/03 Could use an exponential or geometric average... (n/m) - therinL 18:08:20 09/26/03
Post a Followup	You cannot reply to this message because you are not logged in.