Subject	that was for the MDF, but similar process with dimensional
Posted by	OU812 on September 24, 2003 at 8:27 PM
	This message has been viewed 19 times.
In Reply To	thanks for your help, few Q's>> posted by komplexZ on September 24, 2003 at 08:19 PM
Message	wood, only dont warm/cure it as hot (about 100 degrees F will be plenty for that). Good luck, and post your results! Jeff :Was that painting process you described for the fiberboard or wood, or both. If both, than I will try the wood first, since its already made, and if i can't get it smooth enough how I want, then I will try the MDF. Thanks again :)
Follow Ups	suggestions and wood finishing help with my "custom" Z logo - komplexZ 18:29:39 09/24/03 Ash up! (n/m) - ZBlacktt 18:35:56 09/24/03 here is what I would do, as a wood products professional. - OU812 19:47:59 09/24/03 thanks for your help, few Q's>> - komplexZ 20:19:56 09/24/03 that was for the MDF, but similar process with dimensional - OU812 20:27:25 09/24/03
Post a Followup	You cannot reply to this message because you are not logged in.