Subject	How did they figure out horsepower without an RPM reading? (n/m)
Posted by	degradated on September 21, 2003 at 8:37 PM
	This message has been viewed 19 times.
In Reply To	About Torque, chart, etc. posted by Chip(GMS Racing) on September 21, 2003 at 12:36 PM
Message
Follow Ups	Dynoed today on a Mustang dyno at Nopi - Chip(GMS Racing) 23:00:29 09/20/03 11.9 @ 393 hp .... (n/m) - Janders 23:45:23 09/20/03 Pretty good.. how much torque? - degradated 23:58:32 09/20/03 how about a curve, Chip? I'd like to compare.. - Scotts94z32 00:03:24 09/21/03 Geez, Chip, no Pic, no Rwtq # :( (n/m) - ZBlacktt 00:47:43 09/21/03 Musyang dynos are supposed to be more accurate... - D.E.S.A.T.S. 01:51:54 09/21/03 I agree, if we buy a dyno it will be this type - Chip(GMS Racing) 12:39:10 09/21/03 LOL shawn from tampa dynoed his NA he had 201hp with 345tq - Halo Z 03:10:29 09/21/03 Torque was off, they did not monitor RPM - Chip(GMS Racing) 12:38:30 09/21/03 About Torque, chart, etc. - Chip(GMS Racing) 12:36:54 09/21/03 How did they figure out horsepower without an RPM reading? (n/m) - degradated 20:37:38 09/21/03
Post a Followup	You cannot reply to this message because you are not logged in.