Subject	SELLING: Billet fuel rails, SARD/Denso/PE 850cc injectors with extras
Posted by	KongZTT GT28RS MD on April 29, 2014 at 6:35 PM
	This message has been viewed 1004 times.
	Screen Name: KongZTT GT28RS MD Real Name: Shawn Z Phone: 4433503130 Location: Baltimore , md 21001 USA E-mail: shawn300z@hotmail dott com Research KongZTT GT28RS MD's post history
Message	Included are SARD 850cc injectors with billet fuel rail (designed for 90-93 lower plenums, can be used on later models with some machine work of the lower plenum) Blue anodized billet fuel rails with SARD 850cc injectors and injector caps. -6AN SS braided lines -Required -6AN fittings -Stainless steel hardware -New viton upper/lower O-rings even though you wont need them since the ones installed are still new) -Pig tails -Ethanol safe injectors, safe for pump, +10ethanol etc and e85 etc. -Will throw in Earls inline billet aluminum -6AN fuel filter (blue anodized as well) -YOUR Choice of Ashspec 850cc chip OR JWT 850cc chip. Doesn't matter about Dual or Single pop (I have both though).. but most of you will be running a Selin dual MAF converter.. so you can just choose between ADD for single or AVG for dual pop chips. literally less 30 mins of driving (ended up doing a full build and the car is just sitting without engine) You can see there is not even any carbon wear/buildup on the ceramic injector tips. Plenty of members with close to 800rwhp with this setup. They have proven themselves as reliable and great performing setup. With base fuel pressures.. these injectors would be good for a tad more than 850rwhp. Just install these.. and install the chip into your socketed ECU and you're driving! Turn up the boost :) $1050.00 OR $1150 which includes a socketed 8bit TT ECU so you can just plug it into the EFI harness and go :)
Follow Ups	Billet fuel rails, SARD/Denso/PE 850cc injectors with extras - KongZTT GT28RS MD 18:35:38 04/29/14